Choose a Vehicle:






Powered by:



(interested in sponsoring)
Toll Free 888-582-TRNi (8764)
facebook twitter linkedin Wordpress
Tech Forum New Problem
Member Help Request
David Kitchens
08/19/16
2007 HONDA ODYSSEY, neutrals in 3RD after overhaul
The problem now is the customer installed the unit and now it shifts 1-2 neutral. I have disassembled the transmission and do not see any prob...
0 comments open
Mike Bishop
08/11/15
Login to give a Wrench
1959 CHEVROLET IMPALA, FRONT SEAL BLOW OUT
TRANS WAS INSTALLED INTO CAR, CAR DROVE UP ROAD FINE. WENT TO BACK INTO TRAILER AND SEAL BLEW OUT AGANIN. TRANS ON BENCH NOW AND CANT FIND AN...
2 comments closed w/fix
Tom Nicotera
12/05/14
Login to give a Wrench
2004 HYUNDAI SANTA FE, harsh 2;3 shift only
went through relearn fine but nomatter what we do cant get rid of harsh 2-3 shift
1 comments closed w/fix
Jere Fere
11/27/13
2006 NISSAN PATHFINDER, GEARS NOT ENGAGING
AFTER ONE MONTH TRANSMISSION BINDING AND NO GEARS FWD/REV..UPON REMOVAL TORQUE CONVERTER HUB DAMAGED, PUMP GEARS SPLIT..REPLACE PUMP ASSY TWIC...
1 comments open
jason harrison
02/12/13
Login to give a Wrench
1999 AUDI A6, harsh ingagement
do not know problem car gives to many electrical codes to suspect inners to be bad
5 comments closed w/fix
Rodolfo Gonzalez
01/11/13
2008 CHEVROLET SILVERADO 1500, Whining Sound
I took it apart and found some of the clutches in 1-2-3-4 drum were burned a little. The output planet had a little wear in the pinions, So i...
1 comments open w/updates
Chris Wardrop
12/07/12
Login to give a Wrench
2002 JEEP LIBERTY, Stall when put in D
now we install trans and when put in D it will stall set code P0871 and it will fall in limp mode.
1 comments closed w/fix
Jere Fere
11/26/12
Login to give a Wrench
2006 TOYOTA COROLLA, NO LOCK UP WITH TORQUE CONVERTOR SHUTTER
CAME FROM DEALER WITH CODES CLEARED.HAD LOCK UP PROBLEM... REBUILT UNIT WITH BASIC OVERHAUL KIT , NEW TC , AND NEW TCC SOLENOID..CAME BACK WIT...
0 comments closed w/fix
Curtis Pierre
11/24/12
Login to give a Wrench
2007 NISSAN FRONTIER, 3rd gear slip
Overhaul trans on 2 - 3 gear slip remove trans air check everything check out ok . Direct clutch lightly burnt change direct drum as per astg...
2 comments closed w/fix
David VanStean
11/13/12
Login to give a Wrench
2008 FORD FOCUS, downshifts to 1st on 3-4 shift
I am not sure if the problem is in valve body or internal.
2 comments closed w/fix
James Dunwald
04/11/11
2002 CHRYSLER INTREPID, limps
limps hot sets p1776 lr valve stuck scanned looking at soleniod body or valve body?
9 comments open
Rodolfo Gonzalez
04/05/11
Login to give a Wrench
2005 NISSAN PATHFINDER, harsh 3rd gear
Now the tranny shifts but after the first set of shifts the tranny begins to have a harsh shift going to 3rd. I dont have a clue and need some...
12 comments closed w/fix
John Chou
04/01/11
2008 LAMBORGHINI MURCIELAGO, E-gear sometime cann't engage gear
This 2008 LP640 the E-gear sometime cann't engage gear (1orR),and the "N" flash ,I was check the Egear hydraulic system pressure under LARA,w...
1 comments open
Rodolfo Gonzalez
03/31/11
Login to give a Wrench
2005 NISSAN PATHFINDER, hard 3rd gear shift
Rebuilt tranny and foung that the molded pistons were beginning to come apart. So it burnt the low/coast and the high/low clutchs. So now it h...
1 comments closed w/fix
Joe Zahn
03/29/11
Login to give a Wrench
2005 DODGE SPRINTER 2500, eratic shift
Removed v.body to replace conductor plate & connector. I found a solid machined pin,wet w/fluid that fell out from somewhere,lying on the floo...
1 comments closed w/fix
Richard Harmer
03/26/11
2007 MAZDA CX-7, Takes off in High Gear
The vehicle is taking off in 3rd gear. Reverse is fine. Does anyone have experience with this problem? I have read about possible TCM issues.
0 comments open
Rodolfo Gonzalez
03/21/11
Login to give a Wrench
2003 HYUNDAI ACCENT, harsh 3rd and bucking
Now I have a good 1-2 but when its goes to third it is very hard. And when it goes to o/d it bucks and tries to lock up. So just for the hell ...
0 comments closed w/fix
Mike Shuler
03/09/11
2004 MAZDA 3, HARSH KICK DOWN
VERY HARSH 4-3 KICK DOWN ON MED.TO HEAVY EXCEL.ALSO SOME WHAT OF A SLIGHT BUMP ON THE 2-1 DOWN SHIFT
2 comments open
Rodolfo Gonzalez
02/23/11
Login to give a Wrench
2002 FORD F-150 PICKUP, speedo runs too fast
Speedo read all wrong to the point where the rev limiter comes on and set the 1270 code. It even reads mph in reverse and the tranny does not ...
4 comments closed w/fix
Darrell Bierback
02/01/11
Login to give a Wrench
1985 GMC C35/C3500 PICKUP, slipps
allison 653 overhaul gave it to the customer he installed the pto and the transmission into his 3tonn feed mixer truck it didnt make 100 ft fo...
3 comments closed w/fix
Shell McMillian
01/19/11
Login to give a Wrench
2001 AUDI ALLROAD QUATTRO, 2-3 bang
on the third vb and am getting tired of guessing on used ones .
12 comments closed w/fix
Denny Eskins
12/21/10
Login to give a Wrench
2005 NISSAN PATHFINDER, BLOWS TCM FUSE
BLOWS TCM FUSE, SAW BULLETIN ON INTERNET '10-12' CAN'T FIND BULLETIN. NEED HELP WITH ANYONE THAT HAS EXPERIENCED THIS PROBLEM OR HAS ACCESS TO...
0 comments closed w/fix
Bill Hackett
12/08/10
2005 AUDI A4 QUATTRO, rough 5-4 coast down shift
Current Complaint: Slow reverse and drive. Reverse was 3 seconds. Drive was 1,1/2-2 seconds. It has a rough 5-4 coast down shift. The faster y...
2 comments open
Shell McMillian
11/24/10
Login to give a Wrench
1996 JAGUAR XJS, Seems to slip in 1st gear
Works good after it engages but if you put it in neutral or reverse it seems to slip until you push the selector button and make it start off...
1 comments closed w/fix
Gary Marks
11/02/10
Login to give a Wrench
2005 MAZDA 3, lockup does not release
kills motor when down shifts to first
1 comments closed w/fix