Choose a Vehicle:
Fix Database New Problem
| Member | Help Request |
|---|---|
|
Steve Fuller
05/08/12
|
2007 CHEVROLET SUBURBAN 2500, Test Sig Test Sig
0 comments
open
|
|
Harvey Tegeler
02/14/12
Login to give a Wrench
|
2001 CHEVROLET SILVERADO 2500, leaks rear seal complete o/h customer called a week later and said it was still leaking, pulled output housing replaced the orfice ,bushing,seal. Still leaks....
3 comments
closed w/fix
|
|
Robert Profeta
11/30/11
|
2003 CHEVROLET EXPRESS 2500, no line rise no line rise
0 comments
open
|
|
Randal Shimodoi
11/02/11
Login to give a Wrench
|
2004 CHEVROLET SILVERADO 3500, takes 2 to 6 seconds to engauge into gear some times it takes 2to 6 seconds to engageinto forward or rev. checked pressure in d&rev.it would be 60 in drive & some times go to 0.when i...
3 comments
closed w/fix
|
|
Randal Shimodoi
07/14/11
Login to give a Wrench
|
2005 CHEVROLET SILVERADO 3500, no lock up codes 741 ,894
0 comments
closed w/fix
|
|
Randal Shimodoi
07/14/11
Login to give a Wrench
|
2005 CHEVROLET SILVERADO 3500, no lock up codes 741 ,894
2 comments
closed w/fix
|
|
Johnny Valdez
07/07/11
|
2006 GMC SAVANA 2500, tcc will not engage inless 99% duty cycle while monitoring on road test noticed tcc% climbs to 65-70% and slip is still 250 to 300. at that point goes to 99% and then slip speeds go to...
0 comments
open
|
|
Richard Pharr
05/13/11
Login to give a Wrench
|
1999 CHEVROLET C3500 PICKUP, CODE 1860 LOSES 4TH GEAR AND LOCK UP AFTER STOP vehicle shifts fine even has lock up when first driven as soon as you come to a stop and start off again it will not have 4th gear or lock up ...
6 comments
closed w/fix
|
|
Mike Bishop
05/10/11
Login to give a Wrench
|
1999 CHEVROLET K3500 PICKUP, high stall / slipping?? when unit reaches 150deg it starts to slip in fwd and rev. on scan tool input rpm is zero with it slipping/ not moving. if u hold rpm at 2500 ...
14 comments
closed w/fix
|
|
Lewis Christy
04/27/11
|
2007 CHEVROLET SILVERADO 2500 HD, won't move anyone have a problem with reocurring o/drive roller failure?. the roller clutch assembly is not burned up just disentigrated. the bushings al...
3 comments
open
|
|
Scott Plaster
01/28/11
Login to give a Wrench
|
1997 CHEVROLET K2500 PICKUP, starts out in 3rd same
3 comments
closed w/fix
|
|
Earl Folse
01/18/11
Login to give a Wrench
|
2002 CHEVROLET SILVERADO 2500, no reverse now the same problem still exists. I feel reverse engage quite nicely but any throttle trans slips. Forward gears all work excellent
5 comments
closed w/fix
|
|
Joe Zahn
01/17/11
|
2005 CHEVROLET EXPRESS 3500, wont move broke down in n.columbus,by rt.161/n.ave.can anyone help my number is 724-809-5205...thank you
1 comments
open w/updates
|
|
Mike Bishop
12/22/10
Login to give a Wrench
|
1998 GMC K2500 PICKUP, part question when i look in the parts book it says there r to different ones - 4l80e- partial oil hole and 4l80e- through oil hole.
unit back on bench no...
4 comments
closed w/fix
|
|
Greg Trube
09/07/10
|
2005 CHEVROLET EXPRESS 3500, first gear planety noise noise problem
6 comments
open
|
|
Mike Krosevic
07/30/10
Login to give a Wrench
|
2007 CHEVROLET SILVERADO 2500 HD, No lock up Code P0894 Transmission Component Slipping
2 comments
closed w/fix
|
|
Dale Rasco
06/04/10
Login to give a Wrench
|
1996 CHEVROLET C2500 SUBURBAN, NO LOCK-UP Shifts good, computer will not send signal for lock-up. Brake switch always "closed" on scanner, even with switch disconnected. Truck runs ver...
3 comments
closed w/fix
|
|
Randal Shimodoi
05/07/10
Login to give a Wrench
|
1996 CHEVROLET C3500 PICKUP, code po756 engine light goes on when driving for about 15 min.goes into limp in
3 comments
closed w/fix
|
|
Bret Young
02/24/10
|
2000 CHEVROLET C3500 PICKUP, slips on 1-2 shift changed vb did not help pulled unit but cannot find anything wrong
8 comments
open
|
|
Nancy Costa
02/24/10
|
1994 CHEVROLET G30 VAN, no 2nd pulled the unit twice. During the process the vb, ctr support, Dir drum, have been changed. We changed the case this last time. Same result......
10 comments
open
|
|
Daniel Armer
02/13/10
Login to give a Wrench
|
1997 CHEVROLET EXPRESS 3500, 2nd gear no upshift 2nd gear start and no upshift after its hot.
6 comments
closed w/fix
|
|
Tim Beddard
01/08/10
Login to give a Wrench
|
1997 GMC K3500 PICKUP, N/A Original Customer Complaint:
no 4th =, no tcc, harsh shifts
...
25 comments
closed w/fix
|
|
Rodolfo Gonzalez
12/08/09
Login to give a Wrench
|
1993 CHEVROLET C2500 PICKUP, N/A Original Customer Complaint:
car was towed in no movement
...
8 comments
closed w/fix
|
|
Mike Bishop
09/29/09
Login to give a Wrench
|
2005 GMC SIERRA 2500 HD, N/A Original Customer Complaint:
GEAR NOISE IN 1ST GEAR ONLY. SHIFT TO 2ND IT GOES AWAY
...
7 comments
closed w/fix
|
|
Mark Santiso
09/21/09
Login to give a Wrench
|
1997 GMC C3500 PICKUP, N/A Original Customer Complaint:
no up shift after forced down shift
...
25 comments
closed w/fix
|