Choose a Vehicle:
Fix Database New Problem
| Member | Help Request |
|---|---|
|
Chris Wardrop
01/05/12
Login to give a Wrench
|
2005 NISSAN ALTIMA, Delay forward, erattic shifts when hot it has a long delay in drive harsh engagements. late and harsh dowshifts, harsh 1-2 slipping on 2-3 and 3-4 shift. Help, Can my new v...
3 comments
closed w/fix
|
|
Dean Lab
10/27/11
Login to give a Wrench
|
2003 SUZUKI AERIO, very niosy car has a very loud planetary type niose from start off through 3rd,quiet in 4th,and returns on slow to stop,also pinion type noise on accelle...
1 comments
closed w/fix
|
|
Jose Fuentes
10/25/11
Login to give a Wrench
|
2001 FORD F-150 PICKUP, harsh eng. fwd and rev harsh engagement in fwd and rev. I have replace another valve body and another epc(yellow connector)with no results same problem. line pressur...
2 comments
closed w/fix
|
|
Jose Fuentes
09/28/11
Login to give a Wrench
|
2004 NISSAN MAXIMA, 2-3 flare we pull the unit out and found nothing wrong inside that we could see, all frictions are new with their numbers in them and the band was a lit...
1 comments
closed w/fix
|
|
James Mcintosh
08/19/11
|
2002 JAGUAR X-TYPE, stops moving did o/h with torque converter.after rebuild had a delayed engagement,still stops moving after getting hot fluid ,filter cherry. no codes
0 comments
open
|
|
Orville Bolin
08/04/11
Login to give a Wrench
|
2004 MAZDA 3, 3rd slip when warm the vehicle left for 2 days back with 3rd gear problem,this time replaced direct drum and valvebody still same problem
unit always airchecks...
1 comments
closed w/fix
|
|
James Dunwald
04/11/11
Login to give a Wrench
|
2002 CHRYSLER INTREPID, limps limps hot sets p1776 lr valve stuck scanned looking at soleniod body or valve body?
9 comments
closed w/fix
|
|
Rodolfo Gonzalez
04/05/11
Login to give a Wrench
|
2005 NISSAN PATHFINDER, harsh 3rd gear Now the tranny shifts but after the first set of shifts the tranny begins to have a harsh shift going to 3rd. I dont have a clue and need some...
12 comments
closed w/fix
|
|
John Chou
04/01/11
|
2008 LAMBORGHINI MURCIELAGO, E-gear sometime cann't engage gear This 2008 LP640 the E-gear sometime cann't engage gear (1orR),and the "N" flash ,I was check the Egear hydraulic system pressure under LARA,w...
1 comments
open
|
|
Rodolfo Gonzalez
03/31/11
Login to give a Wrench
|
2005 NISSAN PATHFINDER, hard 3rd gear shift Rebuilt tranny and foung that the molded pistons were beginning to come apart. So it burnt the low/coast and the high/low clutchs. So now it h...
1 comments
closed w/fix
|
|
Joe Zahn
03/29/11
Login to give a Wrench
|
2005 DODGE SPRINTER 2500, eratic shift Removed v.body to replace conductor plate & connector. I found a solid machined pin,wet w/fluid that fell out from somewhere,lying on the floo...
1 comments
closed w/fix
|
|
Richard Harmer
03/26/11
|
2007 MAZDA CX-7, Takes off in High Gear The vehicle is taking off in 3rd gear. Reverse is fine. Does anyone have experience with this problem? I have read about possible TCM issues.
0 comments
open
|
|
Rodolfo Gonzalez
03/21/11
Login to give a Wrench
|
2003 HYUNDAI ACCENT, harsh 3rd and bucking Now I have a good 1-2 but when its goes to third it is very hard. And when it goes to o/d it bucks and tries to lock up. So just for the hell ...
0 comments
closed w/fix
|
|
Mike Shuler
03/09/11
|
2004 MAZDA 3, HARSH KICK DOWN VERY HARSH 4-3 KICK DOWN ON MED.TO HEAVY EXCEL.ALSO SOME WHAT OF A SLIGHT BUMP ON THE 2-1 DOWN SHIFT
2 comments
open
|
|
Rodolfo Gonzalez
02/23/11
Login to give a Wrench
|
2002 FORD F-150 PICKUP, speedo runs too fast Speedo read all wrong to the point where the rev limiter comes on and set the 1270 code. It even reads mph in reverse and the tranny does not ...
4 comments
closed w/fix
|
|
Darrell Bierback
02/01/11
Login to give a Wrench
|
1985 GMC C35/C3500 PICKUP, slipps allison 653 overhaul gave it to the customer he installed the pto and the transmission into his 3tonn feed mixer truck it didnt make 100 ft fo...
3 comments
closed w/fix
|
|
Shell McMillian
01/19/11
Login to give a Wrench
|
2001 AUDI ALLROAD QUATTRO, 2-3 bang on the third vb and am getting tired of guessing on used ones .
12 comments
closed w/fix
|
|
Denny Eskins
12/21/10
Login to give a Wrench
|
2005 NISSAN PATHFINDER, BLOWS TCM FUSE BLOWS TCM FUSE, SAW BULLETIN ON INTERNET '10-12' CAN'T FIND BULLETIN. NEED HELP WITH ANYONE THAT HAS EXPERIENCED THIS PROBLEM OR HAS ACCESS TO...
0 comments
closed w/fix
|
|
Bill Hackett
12/08/10
|
2005 AUDI A4 QUATTRO, rough 5-4 coast down shift Current Complaint: Slow reverse and drive. Reverse was 3 seconds. Drive was 1,1/2-2 seconds. It has a rough 5-4 coast down shift. The faster y...
2 comments
open
|
|
Shell McMillian
11/24/10
Login to give a Wrench
|
1996 JAGUAR XJS, Seems to slip in 1st gear Works good after it engages but if you put it in neutral or reverse it seems to slip until you push the selector button and make it start off...
1 comments
closed w/fix
|
|
Gary Marks
11/02/10
Login to give a Wrench
|
2005 MAZDA 3, lockup does not release kills motor when down shifts to first
1 comments
closed w/fix
|
|
Phat Trinh
10/18/10
|
2000 MAZDA MPV, late 1-2 late 1-2 4000rpm
8 comments
open
|
|
Mark Santella
10/15/10
Login to give a Wrench
|
2004 JAGUAR X-TYPE, no move Does anyone know what type of fluid the awd transfer case takes ?
4 comments
closed w/fix
|
|
Chris Wardrop
09/21/10
Login to give a Wrench
|
1998 JEEP CHEROKEE, stalls in reverse It has a verry hard engagement when put in reverse when cold of if is been off for about 20 min. After it gets hot its ok, no more stalling an...
1 comments
closed w/fix
|
|
Robert Ferrel
09/17/10
Login to give a Wrench
|
2003 HYUNDAI ACCENT, Delay in foreward Everything works great except for a 4 second delay in forward. Reverse is fine.
1 comments
closed w/fix
|