Choose a Vehicle:
Fix Database New Problem
| Member | Help Request |
|---|---|
|
Bart Denny
12/05/11
|
1994 TOYOTA 4RUNNER, Repeat T-case front support failure The transfer case front support bushing repeatedly fails in about 300 miles.
4 comments
open
|
|
Robert Profeta
11/30/11
|
2003 CHEVROLET EXPRESS 2500, no line rise no line rise
0 comments
open
|
|
Randal Shimodoi
11/29/11
Login to give a Wrench
|
1999 TOYOTA 4RUNNER, drives fine code 770 keeps coming back.didnt have before rebuilding trans.replace lock up sol. still comes back
0 comments
closed w/fix
|
|
Randal Shimodoi
11/29/11
Login to give a Wrench
|
1999 TOYOTA 4RUNNER, drives fine code 770 keeps coming back.didnt have before rebuilding trans.replace lock up sol. still comes back
0 comments
closed w/fix
|
|
Steve Fuller
11/28/11
Login to give a Wrench
|
2007 JEEP WRANGLER, test phone test phone
0 comments
closed w/fix
|
|
Rodolfo Gonzalez
11/21/11
Login to give a Wrench
|
2000 JEEP CHEROKEE, neutral in 3rd Now it neutral when it shift to 3rd gear. I am thinking something in valvebody. I didnt take apart valvebody (new builder took apart) Can some...
0 comments
closed w/fix
|
|
Phil Van Doeselaar
11/17/11
Login to give a Wrench
|
1992 FORD F-250 PICKUP, no forced down shift Installed trans in vehicle and noticed on test drive, vehicle did not have any forced down shifts and the tcc came on too early around 20 mph,...
8 comments
closed w/fix
|
|
Stephen Sired
11/16/11
|
2004 VOLKSWAGEN JETTA, double apply in forward Harsh double apply in forward. Has 150psi in drive at idle. vbx valve body installed, still the same. Trans controller changed, still the same...
6 comments
open
|
|
Javier Lopez
11/14/11
Login to give a Wrench
|
2002 HONDA ODYSSEY, takes off in high gear will start in first gear then slip a little before it catches 2nd runs fine after that until you come to stop then it seems to be in limp mode...
0 comments
closed w/fix
|
|
Dennis Snook
11/14/11
Login to give a Wrench
|
2008 FORD F-250 SUPER DUTY, assembly question Does anyone know how to remove the low/reverse sprag from the rear planet? They have changed these parts maybe in eary 08. It looks like it is...
2 comments
closed w/fix
|
|
Randal Shimodoi
11/11/11
Login to give a Wrench
|
2005 FORD EXPLORER, slips 3 to 4 slipping into 4th.replaced sol.pack. reset memory.was good for 3 days now same thing.
2 comments
closed w/fix
|
|
Randal Shimodoi
11/11/11
Login to give a Wrench
|
2005 FORD EXPLORER, slips 3 to 4 slipping into 4th.replaced sol.pack. reset memory.was good for 3 days now same thing.
2 comments
closed w/fix
|
|
Randal Shimodoi
11/09/11
Login to give a Wrench
|
1999 FORD F-350 SUPER DUTY PICKUP, no rev sometimes no rev sometimes. let truck sit or drive for awhile and it will go into rev.when it wont move feels like in neutral.
0 comments
closed w/fix
|
|
Randal Shimodoi
11/09/11
Login to give a Wrench
|
1999 FORD F-350 SUPER DUTY PICKUP, no rev sometimes no rev sometimes. let truck sit or drive for awhile and it will go into rev.when it wont move feels like in neutral.
0 comments
closed w/fix
|
|
Randal Shimodoi
11/09/11
Login to give a Wrench
|
1999 FORD F-350 SUPER DUTY PICKUP, no rev sometimes no rev sometimes. let truck sit or drive for awhile and it will go into rev.when it wont move feels like in neutral.
0 comments
closed w/fix
|
|
Mike Bishop
11/08/11
Login to give a Wrench
|
2001 FORD EXPLORER SPORT TRAC, no 4th or 5th replaced valvebody and set of solenoids, (transfered the transgo stuff) reused my separater plate. truck now has delay/ int. slip in rev, and ...
11 comments
closed w/fix
|
|
Chris Wardrop
11/04/11
Login to give a Wrench
|
2001 FORD EXCURSION, codes harsh shifts Harsh shifts when speed sensor codes reset I found tsb on ground isues so i added extra ground to pcm and engie and still the same ting. now t...
11 comments
closed w/fix
|
|
Billy Crawford
11/04/11
Login to give a Wrench
|
2001 BMW 330I, limp mode Scanner data show the engine coolant is 180 degrees but the TCM sees the trans fluid @ 236 degrees when it goes into limp. Replace the temp s...
1 comments
closed w/fix
|
|
Randal Shimodoi
11/02/11
Login to give a Wrench
|
2004 CHEVROLET SILVERADO 3500, takes 2 to 6 seconds to engauge into gear some times it takes 2to 6 seconds to engageinto forward or rev. checked pressure in d&rev.it would be 60 in drive & some times go to 0.when i...
3 comments
closed w/fix
|
|
Dean Lab
10/27/11
Login to give a Wrench
|
2003 SUZUKI AERIO, very niosy car has a very loud planetary type niose from start off through 3rd,quiet in 4th,and returns on slow to stop,also pinion type noise on accelle...
1 comments
closed w/fix
|
|
Robert Ferrel
10/25/11
Login to give a Wrench
|
1995 MERCEDES-BENZ S320, Will not move No engagement !! We have about 70psi in all ranges
0 comments
closed w/fix
|
|
Jose Fuentes
10/25/11
Login to give a Wrench
|
2001 FORD F-150 PICKUP, harsh eng. fwd and rev harsh engagement in fwd and rev. I have replace another valve body and another epc(yellow connector)with no results same problem. line pressur...
2 comments
closed w/fix
|
|
Phil Van Doeselaar
10/24/11
Login to give a Wrench
|
2001 HONDA CIVIC, no reverse Car doesn't have any reverse, it almost seems that when you put it in reverse there is a bind up. The tires don't spin at all. It does move fo...
2 comments
closed w/fix
|
|
Salim Baksh
10/21/11
Login to give a Wrench
|
2005 CHRYSLER PACIFICA, no movement no movement when parked for 12 hours or more after 3 mins of reving the engine its ok went 2 times to there home and never experince...
2 comments
closed w/fix
|
|
Norm Rajotte
10/20/11
|
1983 MERCEDES-BENZ 300SD, no-go came in for front seal leak.resealed front pump.now has a no-go in rev or drive.checkek working pressure-75 psi at 1000rpm.removed and checked...
6 comments
open
|