Choose a Vehicle:
Tech Forum New Problem
| Member | Help Request |
|---|---|
|
Jimmy Rey
03/15/11
Login to give a Wrench
|
2005 GMC SIERRA 1500, bench 2005 4L60E does this trans use o-ring style pump or case seal type pump bench job came in boxes with o-ring style pump case will accept case s...
2 comments
closed w/fix
|
|
Mike Shuler
03/09/11
|
2004 MAZDA 3, HARSH KICK DOWN VERY HARSH 4-3 KICK DOWN ON MED.TO HEAVY EXCEL.ALSO SOME WHAT OF A SLIGHT BUMP ON THE 2-1 DOWN SHIFT
2 comments
open
|
|
Denny Eskins
03/09/11
|
2001 TOYOTA TUNDRA, HARD SHIFTING Shifts hard especially under hard acceleration. Line pressure is about 20 to 25 lbs higher than it should be.
I replaced the line pressure m...
1 comments
open
|
|
Duane Todd
03/07/11
Login to give a Wrench
|
2007 FORD CROWN VICTORIA, no 1st gear rebuilt transmission with clutches,bands solenoids, torque converter.
codes were present prior to rebuild.
solenoids indicate 1st gear com...
8 comments
closed w/fix
|
|
Keith Karel
03/01/11
Login to give a Wrench
|
2005 GMC SIERRA 1500, Shifts 1-4 Came in shop with code P0752. We replaced both solenoids and checked wiring. Code is gone but still shifts 1-4. Scanner shows 1-2, 2-3, 3-4. ...
4 comments
closed w/fix
|
|
Michael Mikus
02/28/11
|
1998 HONDA CIVIC, codes L/U not working or not working correctly.
0 comments
open
|
|
Christopher Hinkle
02/27/11
|
1987 CHEVROLET V20 PICKUP, 1-2 bind, lost reverse smoked lo-rev clutch on first test drive, felt like LR clutch was not releasing in 2nd or 3rd, then lost rev and no hold back in man1, I have ...
9 comments
open
|
|
Brook Smith
02/24/11
Login to give a Wrench
|
1999 FORD F-250 PICKUP, no movement after rebuild problem is still hear new seal kit clutch plates bushings superior v/b kit and transgo acumulator valves rechecked check ball lo...
2 comments
closed w/fix
|
|
Rodolfo Gonzalez
02/23/11
Login to give a Wrench
|
2002 FORD F-150 PICKUP, speedo runs too fast Speedo read all wrong to the point where the rev limiter comes on and set the 1270 code. It even reads mph in reverse and the tranny does not ...
4 comments
closed w/fix
|
|
Michael Mikus
02/23/11
Login to give a Wrench
|
1998 HONDA CIVIC, PO700 - PO740 Codes PO700-trans control module PO740-lockup control circuit. Cannot feel trans l/u and codes after a mile or so.
2 comments
closed w/fix
|
|
Chris Wardrop
02/21/11
Login to give a Wrench
|
2001 HONDA PASSPORT, Burns band after 1 month now it has come back 2 time with the band burn fluid toasted, it wipes out low gear. My question is did I miss something. Or is there a trick ...
6 comments
closed w/fix
|
|
Rodolfo Gonzalez
02/21/11
Login to give a Wrench
|
2001 FORD EXPLORER, shudders tcc Now it works great except when the tcc comes on it shudders just 1-2 seconds when it reaches 40-50 mph.Thinking tc but i really dont want to t...
4 comments
closed w/fix
|
|
Chris Wardrop
02/18/11
Login to give a Wrench
|
2000 HONDA CIVIC, Doble lockup engagement we rebuild the trans and code comes back, lock up does has 2 engagements. I check the power and solenoids they tested ok. Im about to pull it ...
5 comments
closed w/fix
|
|
Dean Lab
02/15/11
Login to give a Wrench
|
2008 DODGE GRAND CARAVAN, buzz or squawk on 2-3 shift returned after 4 months-4600 miles with a noise during the 2-3 shift. the noise is similar to the door locks after take off or a pressure regu...
4 comments
closed w/fix
|
|
Michael Mikus
02/10/11
Login to give a Wrench
|
2003 JAGUAR S-TYPE, Shudder There was codes before I had it,none now and it will not re-code.I tore down used unit and seen no visible damage except scorched fwd clutch...
9 comments
closed w/fix
|
|
Chris Wardrop
02/03/11
Login to give a Wrench
|
2008 DODGE DURANGO, SHUTTER problem still there, worst when hot now we have a code P0868 Line press low. when hot it will shutter in reverse and delay in foward, also a s...
6 comments
closed w/fix
|
|
Frank Defrancesco
02/03/11
Login to give a Wrench
|
2007 CHRYSLER PACIFICA, delay in forward / slips in all forward gears has delay in forward feels like takes off in third until you give heavy gas then takes off in 1st gear and shift threw all gears but slips und...
0 comments
closed w/fix
|
|
Darrell Bierback
02/01/11
Login to give a Wrench
|
1985 GMC C35/C3500 PICKUP, slipps allison 653 overhaul gave it to the customer he installed the pto and the transmission into his 3tonn feed mixer truck it didnt make 100 ft fo...
3 comments
closed w/fix
|
|
Robert Profeta
02/01/11
Login to give a Wrench
|
2003 VOLKSWAGEN JETTA, does not shift cold no shit when cold,wait 5 min then its fine
3 comments
closed w/fix
|
|
Bob Metz
01/29/11
Login to give a Wrench
|
2007 DODGE CALIBER, no upshift when cam in always in low now stuck in hi on take off. Used unit clean was told to reprogram wondering if anybodys worked on these Thanks Bob
1 comments
closed w/fix
|
|
Scott Plaster
01/28/11
Login to give a Wrench
|
1997 CHEVROLET K2500 PICKUP, starts out in 3rd same
3 comments
closed w/fix
|
|
Randal Shimodoi
01/26/11
Login to give a Wrench
|
2005 NISSAN PATHFINDER, limp in limp in when hot
2 comments
closed w/fix
|
|
Randal Shimodoi
01/26/11
|
2005 NISSAN PATHFINDER, limp in limp in when hot
1 comments
open
|
|
Matt Davis
01/23/11
|
1996 GMC SAFARI, no shift wont shift,
4 comments
open
|
|
Shell McMillian
01/19/11
Login to give a Wrench
|
2001 AUDI ALLROAD QUATTRO, 2-3 bang on the third vb and am getting tired of guessing on used ones .
12 comments
closed w/fix
|